HyperLOG® 3000 logarithmic periodic EMC broadband antenna span 380MHz to 18GHz

• DKD ISO calibration certificates available from Aaronia:
  Calibration is performed by comparison with reference standards or reference measurement devices which have been calibrated with the national German calibration service (DKD) and hence are calibrated according to the national reference standards which are used by the federal physical-technical administration (PTB) for maintaining accordance with the international units system (SI).
  
• This calibration is performed in accordance with DIN EN ISO/IEC 17025 and ISO 9001 standards.
  
• The log-periodic antennas of the HyperLOG® 60xx series are suitable for interference field strength measurement. The specialized broadband characteristics allow measurements to be taken in the complete specified frequency range without switching.
  
• These antennas are suitable for measurement according to the following standards and procedures:
  CISPR, VDE, MIL, VG, EN 55011, EN 55013, EN 55015, EN 55022, MIL-Std-461.
  

• Only a single broadband antenna for the complete frequency range from 380MHz to 18GHz
  
• Optimal for usage with spectrum analysers for EMC measurement
  
• Complete ISO calibration certificate (optional)
  
• Top-quality high-tech TEFLON antenna support
  
• Incl. high-tech radom with modern, appealing design
  
• Freely alignable polarisation
  
• Calibration data can be saved to an IC on the antenna and also be read back
  
• Excellent forward/backward ratio
  
• Excellent symmetry of radiation patterns
  
• Integrated 5/8" tripod socket
  
• Suitable for mobile use
  
• Suitable for outdoor installation
  
• Robust design
  
• Splash water proof
  
• Small weight and dimensions
  
• Made in Germany
  
• 10 years warranty
  

HyperLOG 3080:

• Design: Logarithmic-periodic
  
• Frequency range: 380MHz-8GHz
  
• Max. transmission power: 100W CW (400 MHz)
  
• Nominal impedance: 50 Ohms
  
• VSWR (typ.): <1:2,5
  
• Gain (typ.): 5dBi
  
• Antenna factor: 20-43dB/m
  
• Return loss: Better than -10dB
  
• Calibration points: 763 (10MHz steps)
  
• RF connection: SMA socket (18GHz) or N socket using an adapter
  
• Polarisation: linear vertical/horizontal
  
• Tripod connection: 5/8"
  
• Dimensions (L/W/D): (590x360x30) mm
  
• Weight: 1000gr
  
• Warranty: 10 years
  

  
  
  

  
  

  Specifications subject to change without notice
  

HyperLOG 30100:

• Design: Logarithmic-periodic
  
• Frequency range: 380MHz-10GHz
  
• Max. transmission power: 100W CW (400 MHz)
  
• Nominal impedance: 50 Ohms
  
• VSWR (typ.): <1:2,5
  
• Gain (typ.): 5dBi
  
• Antenna factor: 20-46dB/m
  
• Return loss: Better than -10dB
  
• Calibration points: 963 (10MHz steps)
  
• RF connection: SMA socket (18GHz) or N socket using an adapter
  
• Polarisation: linear vertical/horizontal
  
• Tripod connection: 5/8"
  
• Dimensions (L/W/D): (590x360x30) mm
  
• Weight: 1000gr
  
• Warranty: 10 years
  

  
  

  
  

• HyperLOG 30xxx antenna
  
• Typical calibration data with up to 1763 calibration points (10MHz steps!)
  
• Aluminum design carrycase with custom padding
  
• Sturdy, detachable handle with "miniature tripod" mode
  
• Sturdy, multi-purpose aluminum tripod with spirit-level
  
• Special Aaronia SMA toolset with over-torque protection
  

With their log-periodic measurement antennas from the HyperLOG® 3000 series, Aaronia finally offers a very cost-effective alternative, which at the same time meets the highest expectations. In conjunction with the HyperLOG® antennas, every regular spectrum analyser becomes a fully professional directional RF measurement device within a few moments. Thus, a perfect "dream team" for EMC measurement in the laboratory or for outdoor use is at your disposal.
The TEFLON LogPer antennas of the HyperLOG® 3000 series are identical to those of the 6000 series, but have an enhanced frequency range down to 380MHz, particularly for coverage of the important TETRA band. After a huge amount of complex development, a whole series of truely high-tech antennas has evolved, with an exceptional mix of performance, functionality and design in this price category.

Also available with beautiful "transparent" finish (hand-polished) at an extra charge

Inside the Radom, you can find our sophisticated antenna itself, covered with a highly conductive GOLD COATING. This high-grade coating and the antenna's special design warrant excellent linearity over the entire frequency range, and an exceptional receiving or transmitting performance.
Each antenna is calibrated precisely in the Aaronia laboratories before dispatch. It is even possible to permanently store calibration data in a special IC on the antenna. These can later be recalled for dynamic antenna adjustment, for example, with an Aaronia spectrum analyser.