HyperLOG® 7000 LogPer broadband EMC antenna span 700MHz to 6GHz

• DKD ISO calibration certificates available from Aaronia:
  Calibration is performed by comparison with reference standards or reference measurement devices which have been calibrated with the national German calibration service (DKD) and hence are calibrated according to the national reference standards which are used by the federal physical-technical administration (PTB) for maintaining accordance with the international units system (SI).
  
• This calibration is performed in accordance with DIN EN ISO/IEC 17025 and ISO 9001 standards.
  
• The log-periodic antennas of the HyperLOG® 70xx series are suitable for interference field strength measurement. The specialized broadband characteristics allow measurements to be taken in the complete specified frequency range without switching.
  
• These antennas are suitable for measurement according to the following standards and procedures:
  CISPR, VDE, MIL, VG, EN 55011, EN 55013, EN 55015, EN 55022, MIL-Std-461.
  

• Only a single broadband antenna for the complete frequency range up to 6GHz
  
• Optimal for usage with spectrum analysers for EMC measurement
  
• Incl. high-tech radom with modern, appealing design
  
• Freely alignable polarisation
  
• Calibration data can be saved to an IC on the antenna and also be read back
  
• Excellent forward/backward ratio
  
• Excellent symmetry of radiation patterns
  
• Integrated 5/8" tripod socket
  
• Suitable for mobile use
  
• Suitable for outdoor installation
  
• Directional
  
• Robust design
  
• Splash water proof
  
• Small weight and dimensions
  
• Made in Germany
  
• 10 years warranty
  

HyperLOG 7025:

• Design: Logarithmic-periodic
  
• Frequency range: 700MHz-2,5GHz
  
• Max. transmission power: 100W CW (400 MHz)
  
• Nominal impedance: 50 Ohms
  
• VSWR (typ.): <1:2
  
• Gain (typ.): 4dBi
  
• Antenna factor: 23-34dB/m
  
• Return loss: Better than -10dB
  
• Calibration points: 183 (10MHz steps)
  
• RF connection: SMA socket (18GHz) or N socket using an adapter
  
• Polarisation: linear vertical/horizontal
  
• Tripod connection: 5/8"
  
• Dimensions (L/W/D): (340x200x25) mm
  
• Weight: 270gr
  
• Warranty: 10 years
  

  
  
  

  
  

  Specifications subject to change without notice
  

HyperLOG 7040:

• Design: Logarithmic-periodic
  
• Frequency range: 700MHz-4GHz
  
• Max. transmission power: 100W CW (400 MHz)
  
• Nominal impedance: 50 Ohms
  
• VSWR (typ.): <1:2
  
• Gain (typ.): 4dBi
  
• Antenna factor: 23-38dB/m
  
• Return loss: Better than -10dB
  
• Calibration points: 333 (10MHz steps)
  
• RF connection: SMA socket (18GHz) or N socket using an adapter
  
• Polarisation: linear vertical/horizontal
  
• Tripod connection: 5/8"
  
• Dimensions (L/W/D): (340x200x25) mm
  
• Weight: 270gr
  
• Warranty: 10 years
  

  
  

  
  

HyperLOG 7060:

• Design: Logarithmic-periodic
  
• Frequency range: 700MHz-6GHz
  
• Max. transmission power: 100W CW (400 MHz)
  
• Nominal impedance: 50 Ohms
  
• VSWR (typ.): <1:2
  
• Gain (typ.): 5dBi
  
• Antenna factor: 26-41dB/m
  
• Return loss: Better than -10dB
  
• Calibration points: 533 (10MHz steps)
  
• RF connection: SMA socket (18GHz) or N socket using an adapter
  
• Polarisation: linear vertical/horizontal
  
• Tripod connection: 5/8"
  
• Dimensions (L/W/D): (340x200x25) mm
  
• Weight: 250gr
  
• Warranty: 10 years
  

  
  

  
  

• HyperLOG 70xx antenna
  
• Typical calibration data with up to 533 calibration points (10MHz steps!)
  
• Aluminum design carrycase with custom padding
  
• Sturdy, detachable handle with "miniature tripod" mode
  
• Special Aaronia SMA toolset with over-torque protection
  

Also available in a "transparent" finish at an extra charge (polished by hand!)

Simply amazing: The multi-function handle can be turned into a rotatable, practical miniature tripod with very good stability quickly and easily

The Dream team for EMC measurement in the laboratory or in harsh outdoor environments: spectrum analyser and HyperLOG® directional antenna.